How To Install New Graphics on Your MX Bike

Graphics Installation with EDM Shop Girl Lesley Required Tools: Clean Rags – Scissors – Hair Dryer – Contact Cleaner START WITH A CLEAN BIKE! Step 1- WASH YOUR HANDS Clean hands are critical, oily fingers will reduce the ability of your graphics to adhere any place you touch them. Step 2 REMOVE OLD GRAPHICS You can use your hair dryer to warm the old graphics and soften them. Starting on…

Read More >>

How To Set Chain Slack On a Motorcycle – Setting Correct Chain Tension

Chain adjustment simplified with EDM shop girl Laurie K How many different ways have you heard people use to check the chain adjustment on their bike? Seems to me there are almost as many ways as there are riders. Well maybe not quite that many but it sure seems that way. My favorite is the four fingers between the chain and the swing arm. I have seen people use this…

Read More >>

How To Build a Motorcycle Wheel

Building a Motorcycle Wheel With EDM Shop Girl Sara Sponsored by Warp9 Wheels For many riders, wheel building is likely the last thing they think of when a bike related project comes to mind. In most cases, if we are going to do a service that is more than just a basic oil change and filter cleaning it will be a top end rebuild or fork oil change. If the…

Read More >>

How To Install Cams on a Modern 4-Stroke Motorcycle

Today’s modern 4-stroke motors produce heaps of usable power. Most riders can get by using the engine as it comes from the factory in stock form. But what if you are a woods rider looking for more low end power or perhaps you ride MX or you are a desert rider and want more top end and over-rev. How can you fine tune your motor to suit the type of…

Read More >>

New Product – Barnett Heavy Duty KTM Belleville Clutch Spring

The newest addition to their long line of off-road clutch components is their heavy duty Belleville type clutch spring for select 2012-14 KTM models. Made of High Carbon Spring Steel and heat-treated, it’s 20% stiffer than stock and a direct replacement for the stock spring. For optimal performance, install a Barnett Dirt Digger clutch plate kit along with your new spring. This product is made in the USA and competitively…

Read More >>

From Works Connection – Factory Stand 4

Not all stands are made equal, and the WC FS 4, is no different … the newest release from the factory is taller, sturdier and built with a more solid frame and designed specifically with Four-T bikes in mind. The stand has a large 12″ x 12″ top and is tall enough to get both wheels on a 450F, off the ground. The pad on top is solid, tough rubber…

Read More >>

Product Test – Vance and Hines full Exhaust on our CRF450R

Bolting the Vance and Hines XCR Exhaust system onto the Honda CRF450R bike is easy. Using the power the Honda makes after this simple hop up, even easier. The pipe makes the Honda’s power very useable and more controllable from the mid to top. And even though it was meant to add more mid to top, I felt  it added just a little more snap at the bottom as well….

Read More >>